tag:blogger.com,1999:blog-6006114617625504970.post3407248096646326819..comments2024-03-29T00:58:29.857-04:00Comments on Linux Blog: Read - Write support for NTFS partition on OpenSuse 11.xDevOpshttp://www.blogger.com/profile/02331067901785181627noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-6006114617625504970.post-76210649352844074892009-01-25T03:33:00.000-05:002009-01-25T03:33:00.000-05:00For "ntfs-config" you need to install the package ...For "ntfs-config" you need to install the package called "ntfs-config", Now I have mentioned this in the post with screen shot.<BR/><BR/>Thanks,<BR/>NikeshDevOpshttps://www.blogger.com/profile/02331067901785181627noreply@blogger.comtag:blogger.com,1999:blog-6006114617625504970.post-21919718345530302372009-01-24T03:35:00.000-05:002009-01-24T03:35:00.000-05:00Same for me, i can't find ntfs-config on my system...Same for me, i can't find ntfs-config on my system. I run openSUSE 11.0Unknownhttps://www.blogger.com/profile/10899882558250167147noreply@blogger.comtag:blogger.com,1999:blog-6006114617625504970.post-1653875886915294212009-01-15T12:43:00.000-05:002009-01-15T12:43:00.000-05:00I have openSUSE 11.0 installed which uses ntfs-3g....I have openSUSE 11.0 installed which uses ntfs-3g. The package ntfs-progs is also installed, but there is no utility ntfs-config on my system?Anonymousnoreply@blogger.comtag:blogger.com,1999:blog-6006114617625504970.post-66048515926276725692009-01-15T04:11:00.000-05:002009-01-15T04:11:00.000-05:00In my case it works for me without restart. When I...In my case it works for me without restart. When I plug my NTFS HDD (I have a Promise SATAII to PCI adapter and Vantec racks in 5,25" slots)openSUSE 11.1 (x86-64)detects it as a Hard Drive without any problem. After that I use ntfs-config and my NTFS HDD becomes fully operating. No restart. Under any older oS version my NTFS HDDs became accessible after reboot only.Anonymousnoreply@blogger.com